Martin Audio ENGINEER Guia do Utilizador descarregar pdf (Página 17)

Engineer 418 & 818 User Manual Page 17

Connection instructions for Phoenix terminal blocks

To connect the Phoenix terminal blocks, always use the following procedure:

 strip the jacket 20mm

 strip the wires 7 mm

 DO NOT pre tin the wires

 cover the ground wire with a heat shrink sleeving

 put the wire up to the plastic sleeve in the terminal block

 use a small flathead screwdriver to firmly close the contact

 make a strain relief so no stain is on the connection

 for suitable wire thickness, please refer to the table below

Conductor cross section solid min. 0.2 mm

Conductor cross section solid max. 2.5 mm

Conductor cross section stranded min. 0.2 mm

Conductor cross section stranded max. 2.5 mm

Conductor cross section stranded, with ferrule without plastic sleeve min. 0.25 mm

Conductor cross section stranded, with ferrule without plastic sleeve max. 2.5 mm

Conductor cross section stranded, with ferrule with plastic sleeve min. 0.25 mm

Conductor cross section stranded, with ferrule with plastic sleeve max. 2.5 mm

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 79 80

Sem comentários

Martin Audio ENGINEER Guia do Utilizador Página 17